I believe the DMZplus setting on the Pace gateway creates almost a separate network for those devices configured in this manner. I will keep looking into this, but for now, while the B996 and ARC app work in my home, I am unable to test it outside of my LAN. I have spent the past two hours reviewing and testing configuration options between the AT&T gateway and my ASUS subnet, and do not see a path forward. Unfortunately, this gateway does not support UPNP, and port forwarding and/or removing the gateway’s NAT function for a cascaded router network is not really configurable either. The AT&T gateway serves only to bring the fiber and phone service together, and then all other data traffic is managed within the ASUS network subnet. Based on the age of the gateway (which is required for our service) and their configuration options, I also run an ASUS AiMesh network for my home LAN for all connected devices. I am on AT&T Fiber using their Pace 5268AC gateway. I was able to install B996 on my 2019 MacBook Pro, went into TestFlight and installed ARC B25 on my iPhone 11, and started to work on configuring the network. When your selections display in Hosted Applications, select Save.So I have to call no joy due to my network configuration and provider (AT&T Fiber).From Needed by Device, select the device name or IP address of the device to open the port.Your new applications or devices will display in the Applications list. When all applications or devices have been added, select Return to NAT/Gaming.Repeat as needed for additional applications and devices. Select the appropriate Protocol from the drop-down for the application or device you're adding.In Base Host Port, enter the port number used for the first Global Port Range section.In this case, the port number should be the same in the Global Port Range fields. It's recommended to create a separate service entry for each port as opposed to using a port range. Enter the port(s) you wish to open for Global Port Range.In Service Name, enter the name for the application or device.If your application isn't in the list, or you're setting up port forwarding for a device: From Service, select the application for port forwarding.If you get a warning message, restart your Wi-Fi gateway.Enter the Device Access Code found on the side of your gateway.To open a port for user-defined applications:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |